Jacenyr Intelligent Technology
The source strength manufacturer of nylon cable tie automatic strapping machine
The source strength manufacturer of nylon cable tie automatic strapping machine
Please open the cover and see the elastic screws on both sides of the pulling wheel. Loosen the roms first and tighten the screws after adjusting the pulling wheel to the appropriate distance.
Date：2023-02-28
If the parameters are incorrectly adjusted, please restore the parameters retained before delivery, or contact the technician of the manufacturer directly, or replace the cable ties with the previous ones because the cable ties are deformed. Check the cable ties to ensure the quality of the cable ti..
Date：2023-02-28
The reason is that there is dirt in the vibration disk, the vibration disk is set slowly, and there is too much material in the vibration disk. It is necessary to clean the vibration disk and reset the speed, and part of the material is taken out.
Date：2023-02-28
Please check whether the vibration disk is properly connected to the machine interface. After the connection is properly connected, tighten the four small fixing screws of the vibration disk to ensure that the vibration disk is full of materials before it starts to work. Nylon cable ties more burr o..
Date：2023-02-28
189-2252-0163
